Structural Testing & Engineering Services
From sub-soil investigation through to piling, drawings and repairs — testing that tells you what's there, and the engineering to act on it.
Non-Destructive Integrity Testing
Assess structural condition without damaging the structure.
Structural condition assessed using methods that don't damage or disrupt the asset — applied to roads, buildings and bridges to determine integrity without taking them out of service.
- Confirms condition without disrupting use of the structure
- Detects deterioration before it becomes visible or urgent
- Applies across roads, buildings and bridges
Concrete Compressive Strength Testing
Confirm concrete has reached the strength the design requires.
Concrete strength tested against the design specification, before load is placed on the structure or before work proceeds to the next stage.
- Confirms concrete meets design strength before it's load-bearing
- Catches under-strength concrete before it's built over
- Required for stage sign-off on most construction projects
Pile Integrity & Pile Load Testing
Verify pile continuity and load capacity before you build on it.
Piles tested for structural continuity and load-bearing capacity — before a structure is built on top, or after settlement raises doubt about an existing pile.
- Confirms piles are sound before they carry structural load
- Identifies pile defects that aren't visible from the surface
- Applies to both new piling and investigation of existing foundations
Sub-soil Investigation
Know what you're building on before you build.
Ground bearing capacity and composition determined through sub-soil investigation, before foundation design begins.
- Prevents costly foundation redesign later
- Establishes bearing capacity and settlement risk
- Required for most municipal approvals
Piling Works & Foundation Repairs
Correct a failing foundation, or install piling where ground conditions demand it.
Piling installation and foundation repair carried out where sub-soil investigation shows the existing foundation is inadequate, or where ground conditions require piled support from the start.
- Addresses settlement, cracking or movement at the source
- Piling scoped to the ground conditions confirmed by testing, not estimated
- Suited to both new construction and remedial work on existing structures
Structural Drawing Production
Structural drawings prepared for approval, construction or as-built record.
Structural drawings produced to support design approval, construction, or renovation work — reflecting either the intended design or the as-built condition confirmed by inspection.
- Provides the drawing set regulators and contractors require
- Aligns drawings with actual site or structural conditions
- Supports both new-build design and renovation planning
Project Management
Coordinate the project from design through completion.
Engineering oversight of a construction or renovation project — coordinating design, contractors and compliance through to completion.
- Single point of accountability across the project
- Reduces risk of design and construction falling out of alignment
- Engineering oversight through to project completion
Building Repairs & Renovations
Repair or renovate a structure based on its actual condition, not guesswork.
Repair and renovation work carried out on existing structures, informed by structural integrity assessment where prior testing has identified the cause of damage or deterioration.
- Repairs address the diagnosed cause, not just the visible symptom
- Renovation scoped against the structure's actual condition
- Suited to buildings with known cracking, settlement or deterioration
Not sure which service you need?
Tell us about the project and we'll recommend the right testing or assessment.